Nissan Ariya: Symptom Diagnosis

• Combination Switch System Symptoms
• Normal Operating Condition

Combination Switch System Symptoms

Symptom Table

1. Perform “Data Monitor” of CONSULT to check for any malfunctioning item.

2. Check that the data monitor display switches in conjunction with the combination switch operation.

3. If there is a switch whose display does not change, specify the applicable combination switch circuit (INPUT 1 - 6 and OUTPUT 1 - 5) using the combination switch circuit confirmation table for the circuit used for that switch.

   NOTE:

   Since combination switch circuit is share with multiple switches, if the switches used other than the defective switch are normal, the combination switch circuit can be determined to be normal.

   Example: If the circuit used for the switch corresponds to INPUT 1 and OUTPUT 2 of the combination switch circuit, but the other switches that use the INPUT 1 circuit are normal, it is determined that the INPUT 1 circuit is normal and inspection OUTPUT 2 circuit. If other switches that use OUTPUT 2 circuit are normal, the combination switch circuit (INPUT 1 and OUTPUT 2) is determined to be normal, and it can be determined that the combination switch is defective.

   Circuit used: ×

   Combination switch circuit confirmation table

   Data monitor item		Combination switch circuit
   Sub system	Data monitor item	INPUT 1	INPUT 2	INPUT 3	INPUT 4	INPUT 5	INPUT 6	OUTPUT 1	OUTPUT 2	OUTPUT 3	OUTPUT 4	OUTPUT 5
   COMB SW	Check diode 1	×						×
   	High beam switch	×							×
   	Passing switch	×								×
   	Front fog switch	×										×
   	INT volume 1		×					×
   	Check diode 2		×						×
   	Low beam switch		×							×
   	AUTO light switch*1		×								×
   	Tail lamp switch		×									×
   	Front washer switch			×				×
   	Rear washer switch			×					×
   	Check diode 3			×						×
   	Turn signal LH			×							×
   	Turn signal RH			×								×
   	Front wiper LO				×			×
   	Front wiper HI				×				×
   	Front wiper INT				×					×
   	Check diode 4				×						×
   	Light OFF switch*2				×							×
   	INT volume 2					×		×
   	INT volume 3					×			×
   	Rear wiper INT					×				×
   	Rear wiper ON					×					×
   	Check diode 5					×						×
   	Front wiper OFF						×	×
   	Front wiper MIST						×		×
   BCM	High beam assist switch						×					×

   NOTE:

   *1: This item is displayed, but cannot be monitored. (Without lighting switch OFF position)

   *2: “Light OFF switch” is indicated on CONSULT display, however this means lighting switch AUTO position on this Nissan Ariya vehicle. (Without lighting switch OFF position)

4. Identify the possible malfunctioning part from combination switch circuit confirmation table and inspection or replace it.

   Possible malfunction part / Symptom		Inspection / Replace
   Some data monitor displays do not switch	There is a malfunction with either of the combination switch INPUT circuit	Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure.
   	There is a malfunction with either of the combination switch OUTPUT circuit	Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure.
   	It is not applicable to any of the combination switch INPUT circuit and OUTPUT circuit	Replace combination switch. Refer to Removal and Installation. If the data monitor display does not switch for a specific switch, the corresponding switch has a malfunction.
   All data monitor displays do not switch		Replace BCM. Refer to Removal and Installation.
   All data monitor displays switch		Check intermittent incident. Refer to Intermittent Incident.

Normal Operating Condition

Description

SHIPPING MODE

• Shipping mode inhibits battery power consumption during transportation or storage of the Nissan Ariya vehicle. Vehicle is set to shipping mode before being shipped from the factory.

• When power switch is OFF, BCM operates shipping mode.

• For shipping mode cancel operation, refer to Work Procedure.

  NOTE:

  Do not cancel shipping mode during storage of the Nissan Ariya vehicle. Always cancel shipping mode before delivery of the vehicle to customer.

Diagnosis System (bcm)Removal and Installation